By Dr Colin Mercer, Technical Director, Prosig
A shaft has been instrumented with two shaft encoders, one at each end. Each shaft encoder gives out a once/rev pulse and a 720 pulses/rev signal. Each signal was digitised at 500,000 samples/second. The objective is to measure the twist in the shaft and analyze into orders. The test stand was already equipped with a data acquisition system so a Prosig acquisition system was not required. Instead it was decided that the data captured by the resident system would be imported into the DATS software. The only format available from the customer system was ‘comma separated variables’ or CSV. This is not ideal as it is an ASCII based format and therefore creates very large files. read »»»
By Dr Colin Mercer, Technical Director, Prosig
When working with audio signals a common requirement is to be able to equalise, cut or boost various frequency bands. A large number of hardware devices on the market provide this capability. The key aspect is that such filters are able to control bandwidth, centre frequency and gain separately. There are broadly two classes of filter used, a “shelving” filter and an “equalising “filter (also known as a “peak” filter). A shelving filter is akin to low pass and high pass filters. An equalising filter is like a bandpass or band reject filter. read »»»
By Dr Colin Mercer, Technical Director, Prosig
It is sometimes necessary to pass a signal through a high pass filter to eliminate low frequency signals. These may arise for instance from whole body vibrations when perhaps our interest is in higher frequency components from a substructure such as an engine or gearbox mounting. The vibration levels are speed sensitive and the usual scheme is to record a once per revolution ‘tacho’ signal with the vibration data. The tacho signal, which ideally is a nice regular pulse train, is processed to find rotational speed and hence to select which part of the vibration signal is to be frequency analysed. The most common form of analysis is a waterfall type such as shown below. read »»»
By Dr Colin Mercer, Technical Director, Prosig
In many instances we need to filter a signal to remove unwanted frequencies. If we use classical filters such as Butterworth, Chebyshev or even Bessel then a phase delay is introduced. This phase delay is itself a function of frequency so that the signal content at one frequency is delayed a different amount to that at another frequency. Why does this matter? read »»»
