Read more about the article Torsional Vibration, Tacho Pulses And Aliasing

Torsional Vibration, Tacho Pulses And Aliasing

With shafts, gears and the like, the general method of determining the rotational speed is to use some form of tachometer or shaft encoder. These give out a pulse at regular angular intervals. It we have N pulses per rev then obviously we have a pulse every (360/N) degrees. Determining the speed is nominally very simple: just measure the time between successive pulses. If this period is Tk seconds and the angle travelled is (360/ N) degrees then the rotational speed is simply estimated by 360/(N*Tk) degrees/second or 60/(N*Tk) rpm.

(more…)

Continue ReadingTorsional Vibration, Tacho Pulses And Aliasing
Read more about the article Measuring Torsional Twist & Vibration Along a Shaft or Through a Geartrain

Measuring Torsional Twist & Vibration Along a Shaft or Through a Geartrain

The measurement of torsional twist, or the twist angle, between two points along a shaft or through a gear train may be derived from a pair of tacho signals, one at each end of the shaft. Typically the tacho signals would be derived from gear teeth giving a known number of pulses/revolution. For example one end of a shaft could have a gear wheel with say 60 teeth giving 60 pulses/revolutions when measured with say an inductive or eddy current probe. (more…)

Continue ReadingMeasuring Torsional Twist & Vibration Along a Shaft or Through a Geartrain